Toyota CH-R Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL FRONT DOOR BELT MOULDING ASSEMBLY

Install in this Direction

(a) Engage the claws to install a new front door belt moulding assembly as shown in the illustration.

(b) Remove the protective tape.

2. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Click here

3. INSTALL FRONT DOOR SERVICE HOLE COVER

Click here

4. INSTALL OUTER REAR VIEW MIRROR ASSEMBLY

Click here

5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Click here

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

6. INITIALIZE POWER WINDOW CONTROL SYSTEM

Click here

7. INSPECT POWER WINDOW OPERATION

Click here

    Components
    COMPONENTS ILLUSTRATION *1 FRONT DOOR BELT MOULDING ASSEMBLY *2 FRONT DOOR GLASS SUB-ASSEMBLY *3 FRONT DOOR SERVICE HOLE COV ...

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ...

    Other materials:

    Toyota CH-R Service Manual > Blind Spot Monitor System: Precaution
    PRECAUTION IGNITION SWITCH EXPRESSIONS (a) The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ignition Switch (Position) Engine Swi ...

    Toyota CH-R Service Manual > Airbag System: Diagnosis System
    DIAGNOSIS SYSTEM CHECK DLC3 (a) Check the DLC3. Click here FUNCTION OF SRS WARNING LIGHT (a) Primary check (1) Turn the ignition switch off. Wait for at least 2 seconds, then turn the ignition switch ON. The SRS warning light comes on for approximately 6 seconds and diagnosis of the airb ...

    © 2017-2019 Copyright www.tochr.net
    0.0165