COMPONENTS
ILLUSTRATION
|
*1 |
FRONT DOOR BELT MOULDING ASSEMBLY |
*2 |
FRONT DOOR GLASS SUB-ASSEMBLY |
|
*3 |
FRONT DOOR SERVICE HOLE COVER |
- |
- |
|
N*m (kgf*cm, ft.*lbf) : Specified torque |
● |
Non-reusable part |
InstallationToyota CH-R Service Manual > Blower Unit(for Denso Made): Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration)
that must be performed after parts are removed and installed, or replaced during
blower unit removal/installation are shown below.
Necessary Procedure After Parts Removed/Install ...
Toyota CH-R Service Manual > Rear Bumper: Removal
REMOVAL
PROCEDURE
1. REMOVE REAR BUMPER SIDE SEAL LH
(a) Remove the 7 clips and rear bumper side seal LH.
2. REMOVE REAR BUMPER SIDE SEAL RH
HINT:
Use the same procedure as for the LH side.
3. SEPARATE QUARTER OUTSIDE MOULDING LH
(a) ...