COMPONENTS
ILLUSTRATION
|
*A |
for Driver Side |
*B |
for Front Passenger Side |
|
*1 |
FRONT DOOR INSIDE HANDLE BEZEL PLUG |
*2 |
FRONT DOOR LOWER FRAME BRACKET GARNISH |
|
*3 |
FRONT DOOR TRIM BOARD SUB-ASSEMBLY |
*4 |
FRONT DOOR WEATHERSTRIP |
|
*5 |
MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL |
*6 |
POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL |
ILLUSTRATION
|
*A |
for TMMT Made |
*B |
for TMC Made |
|
*1 |
DOOR FRAME UPPER GARNISH |
*2 |
FRONT DOOR BELT SEAL |
|
*3 |
FRONT DOOR FIX WINDOW GLASS |
*4 |
FRONT DOOR FRONT LOWER FRAME SUB-ASSEMBLY |
|
*5 |
FRONT DOOR GLASS INNER WEATHERSTRIP |
*6 |
FRONT DOOR GLASS RUN |
|
*7 |
FRONT DOOR GLASS SUB-ASSEMBLY |
*8 |
FRONT DOOR SERVICE HOLE COVER |
|
*9 |
FRONT DOOR VENT SEAL |
*10 |
OUTER REAR VIEW MIRROR ASSEMBLY |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
ILLUSTRATION
|
*1 |
FRONT DOOR OUTSIDE STRIPE |
*2 |
NO. 2 FRONT DOOR STRIPE |
|
*3 |
NO. 4 FRONT DOOR STRIPE |
- |
- |
|
● |
Non-reusable part |
- |
- |
RemovalToyota CH-R Service Manual > Power Steering Ecu: Installation
INSTALLATION
PROCEDURE
1. INSTALL ELECTRIC POWER STEERING MOTOR SHAFT DAMPER
Grease
(a) Apply grease to a new electric power steering motor shaft damper.
NOTICE:
First wipe off the existing grease from the serrated part, and then apply the
dedicated grease supp ...
Toyota CH-R Service Manual > Rear Door Belt Moulding: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. INSTALL REAR DOOR BELT MOULDING ASSEMBLY
(a) Engage the claws to install a new rear door belt moulding assembly as shown
i ...