COMPONENTS
ILLUSTRATION
|
*1 |
REAR SHOCK ABSORBER ASSEMBLY |
*2 |
REAR STABILIZER LINK ASSEMBLY |
|
*3 |
REAR UPPER CONTROL ARM ASSEMBLY |
*4 |
REAR STABILIZER BAR |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
* |
For use with a ball joint lock nut wrench |
ILLUSTRATION
|
*1 |
REAR SHOCK ABSORBER ASSEMBLY |
*2 |
REAR SHOCK ABSORBER CAP |
|
*3 |
REAR SUSPENSION SUPPORT ASSEMBLY |
*4 |
REAR SUPPORT TO REAR SHOCK ABSORBER NUT |
|
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |
* |
For use with SST |
|
● |
Non-reusable part |
|
Adhesive 1324 |
|
★ |
Precoated part |
- |
- |
RemovalToyota CH-R Service Manual > Meter / Gauge System: Open in Turn Signal Circuit (B1507,B1508)
DESCRIPTION
These DTCs are stored when the combination meter assembly detects an open in
a turn signal light circuit, or a short in a turn signal light circuit or the hazard
warning light circuit.
DTC No.
Detection Item
DTC Detection Condition
Troubl ...
Toyota CH-R Service Manual > Immobiliser System(w/o Smart Key System): Engine does not Start but Initial Combustion Occurs
DESCRIPTION
If the key ID codes of the key and transponder key ECU assembly match, the immobiliser
system is unset and the engine start permission signal is sent to the ECM. When
the ID codes of the transponder key ECU assembly and ECM match, the engine starts.
WIRING DIAGRAM
CAUTION / NOTI ...