Toyota CH-R Service Manual: Installation

Toyota CH-R Service Manual / Steering Column / Steering Wheel / Installation

INSTALLATION

CAUTION / NOTICE / HINT

NOTICE:

  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the ignition switch ON.
  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed with the battery connected and the ignition switch ON.
  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

PROCEDURE

1. INSTALL STEERING PAD SWITCH ASSEMBLY

Click here

2. INSTALL CRUISE CONTROL MAIN SWITCH

Click here

3. INSTALL LOWER NO. 2 STEERING WHEEL COVER

Click here

4. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD

5. INSPECT AND ADJUST SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

Click here

6. INSTALL STEERING WHEEL ASSEMBLY

(a) Align the matchmarks on the steering wheel assembly and steering main shaft to install the steering wheel assembly.

*a

Matchmark

(b) Install the steering wheel assembly set nut.

Torque:

50 N·m {510 kgf·cm, 37 ft·lbf}

(c) w/ Steering Heater:

(1) Connect the steering heater connector.

(d) Connect the 2 connectors to the spiral cable with sensor sub-assembly.

7. CHECK STEERING WHEEL CENTER POINT

8. INSTALL HORN BUTTON ASSEMBLY

Click here

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during th ...

    Steering Gear / Linkage
    ...

    Other materials:

    Toyota CH-R Service Manual > Immobiliser System(w/ Smart Key System): Dtc Check / Clear
    DTC CHECK / CLEAR NOTICE: When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type u ...

    Toyota CH-R Service Manual > Radio Antenna Cord: Installation
    INSTALLATION PROCEDURE 1. INSTALL NO. 3 ANTENNA CORD SUB-ASSEMBLY (a) w/o Manual (SOS) Switch (1) Engage the clamp and guide to temporarily install the No. 3 antenna cord sub-assembly. *A ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0091