Toyota CH-R Service Manual: Dtc Check / Clear

NOTICE:

• The steering lock ECU (steering lock actuator or upper bracket assembly) does not store history DTCs. If any DTCs are output, confirm and record them as soon as possible. Do not turn the engine switch off or clear the DTCs until the DTCs are confirmed and recorded.
• DTCs may have been stored due to problems unrelated to the steering lock system. Be sure to confirm and record any DTCs output for other systems.
• When using the Techstream with the engine switch off, connect the Techstream to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type under manual mode and enter the following menus: Body Electrical / Smart Key. While using the Techstream, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the Techstream and the vehicle.

Diagnosis System

DIAGNOSIS SYSTEM DESCRIPTION (a) The steering lock ECU (steering lock actuator or upper bracket assembly) stores DTCs when a malfunction occurs in the system. These DTCs can be confirmed by usin ...

Data List / Active Test

DATA LIST / ACTIVE TEST READ DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any ...

Other materials:

Toyota CH-R Service Manual > Smart Key System(for Start Function): Power Source Mode does not Change to ON (IG)
DESCRIPTION If the engine switch is pressed with the electrical key transmitter sub-assembly in the cabin, the certification ECU (smart key ECU assembly) receives a signal and changes the power source mode. Related Data List and Active Test Items Problem Symptom Data Lis ...

Toyota CH-R Service Manual > Rear Door Courtesy Switch: Inspection
INSPECTION PROCEDURE 1. INSPECT REAR DOOR COURTESY LIGHT SWITCH ASSEMBLY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. Standard Resistance: Tester Connection Condition Spec ...