Toyota CH-R Owners Manual: Personal lights

Turns the lights on/off

When the lights are on due to the door link switch, a light will not turn off even if its switch is pressed.

Toyota CH-R. Using the interior lights

■Illuminated entry system

Vehicles without a smart key system

When the interior light switch is in the door position, the interior lights automatically turn on/off according to the engine switch position, whether the doors are locked/unlocked and whether the doors are open/closed.

Vehicles with a smart key system

When the interior light switch is in the door position, the interior lights and engine switch light automatically turn on/off according to engine switch mode, the presence of the electronic key, whether the doors are locked/unlocked and whether the doors are open/closed.

■Outer mirror illumination (if equipped) The illumination automatically turns on according to the presence of the electronic key (vehicles with a smart key system), or the doors are unlocked.

■To prevent battery discharge The following lights will turn off automatically after 20 minutes:

  • Front interior light/front personal lights
  • Rear interior light
  • Luggage compartment light
  • Vanity lights (if equipped)

■Customization Settings (e.g. the time elapsed before lights turn off) can be changed.

    Interior lights
    ■ Front Turns the door position on/off ■ Rear On Door position Operation is linked with the front interior light main switch. When the switch is off, the light does not illuminate. ...

    Using the storage features
    ...

    Other materials:

    Toyota CH-R Service Manual > Meter / Gauge System: Lost Communication with ECM / PCM "A" (U0100,U0129,U0131,U0142,U0151,U0182,U0235,U023A)
    DESCRIPTION The combination meter assembly communicates with the ECM, brake actuator assembly (skid control ECU), power steering ECU assembly, main body ECU (multiplex network body ECU), airbag sensor assembly, headlight control ECU sub-assembly LH*1, front camera module*2, millimeter wave ra ...

    Toyota CH-R Service Manual > Immobiliser System(w/o Smart Key System): Terminals Of Ecu
    TERMINALS OF ECU CHECK TRANSPONDER KEY ECU ASSEMBLY (a) Disconnect the F22 transponder key ECU assembly connector. (b) Measure the resistance and voltage according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector disconnected. ...

    © 2017-2020 Copyright www.tochr.net
    0.0153