Toyota CH-R Service Manual: Freeze Frame Data

FREEZE FRAME DATA

DESCRIPTION

The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was moving or stationary, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction.

HINT:

If it is impossible to reproduce the symptoms even though a DTC is stored, confirm the freeze frame data.

PENDING FREEZE FRAME DATA

HINT:

Pending freeze frame data is stored when a 2 trip DTC is first detected during the first trip.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

Powertrain > Engine and ECT > Trouble Codes

(e) Select a DTC in order to display its pending freeze frame data.

HINT:

  • Pending freeze frame data is cleared when any of the following occurs:
    • Using the Techstream, the DTCs are cleared.
    • The cable is disconnected from the negative (-) battery terminal.
    • 40 trips with the engine fully warmed up have been performed after condition returning to normal. (Pending freeze frame data will not be cleared only by the system returning to normal.)
  • With previous pending freeze frame data stored, if pending freeze frame data is newly stored when a 2 trip DTC is detected in the first trip, the old freeze frame data will be replaced with the new data of the newly detected DTC in the next trip.

LIST OF FREEZE FRAME DATA

Powertrain > Engine and ECT

Tester Display

Battery Voltage

Alternator Output Duty

Alt Vol - Non Active Test

Alt Vol - Active Test

    Dtc Check / Clear
    DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Powertrain / Engine and ECT / Tr ...

    Data List / Active Test
    DATA LIST / ACTIVE TEST DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any part ...

    Other materials:

    Toyota CH-R Service Manual > Airbag System: Side Airbag Sensor Assembly No.2 Lost Communication (LH) (B163B/86,B163C/86)
    DESCRIPTION The side collision sensor LH circuit (bus 2) consists of the airbag sensor assembly and floor side airbag sensor LH. The floor side airbag sensor LH detects impacts to the vehicle and sends signals to the airbag sensor assembly to determine if the airbags and pretensioners should ...

    Toyota CH-R Service Manual > Ptc Heater Assembly: Removal
    REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE LH Click here 2. REMOVE COWL SIDE TRIM BOARD LH Click here 3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 4. REMOVE NO. 1 AIR DUCT Click here 5. REMOVE NO. 2 HEATER COVER (for VALEO Made) ( ...

    © 2017-2019 Copyright www.tochr.net
    0.0175