Toyota CH-R Service Manual: Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL SHIFT LEVER HOUSING BRACKET SUB-ASSEMBLY

(a) Engage the 4 claws to install the shift lever housing bracket sub-assembly to the shift lock control unit assembly.

2. INSTALL SHIFT POSITION INDICATOR

(a) Install the shift position indicator to the upper console panel sub-assembly with the 3 screws.

3. INSTALL SHIFTING HOLE COVER SUB-ASSEMBLY

(a) Engage the 4 guides and 6 claws to install the shifting hole cover sub-assembly to the upper console panel sub-assembly.

    Inspection
    INSPECTION PROCEDURE 1. INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY (w/o Smart Key System) HINT: If the results of the following inspections are as specified but a malfunction has occurred, replace ...

    Installation
    INSTALLATION PROCEDURE 1. INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY (a) Temporarily install the floor shift shift lever assembly to the body with the 4 bolts. (b) Fully tighten the 4 bolts in t ...

    Other materials:

    Toyota CH-R Service Manual > Id Code Box: Installation
    INSTALLATION CAUTION / NOTICE / HINT NOTICE: Before replacing the ID code box (immobiliser code ECU), refer to Registration. Click here PROCEDURE 1. INSTALL ID CODE BOX (IMMOBILISER CODE ECU) (a) Engage the guides to install the ID code box (immobiliser code ECU) as shown in the illustrat ...

    Toyota CH-R Service Manual > Power Window Control System: Terminals Of Ecu
    TERMINALS OF ECU CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (a) Disconnect the J6 multiplex network master switch assembly connector. (b) Measure the voltage and resistance according to the value(s) in the table below. HINT: Measure the values on the wire harness side with the connector ...

    © 2017-2021 Copyright www.tochr.net
    0.0171