Toyota CH-R Service Manual: Removal

Toyota CH-R Service Manual / Parking Brake / Electric Parking Brake Actuator / Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.

PROCEDURE

1. PRECAUTION

Click here

2. RELEASE PARKING BRAKE

(a) Move the shift lever to P.

(b) Turn the ignition switch to ON.

HINT:

If the parking brake cannot be released:

for TMC Made:
Click here
for TMMT Made:
Click here

(d) Turn the ignition switch off.

3. REMOVE REAR WHEEL

Click here

4. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY

(a) Disconnect the No. 2 parking brake wire assembly connector from the parking brake actuator assembly.

NOTICE:

Remove any dirt or foreign matter on and around the No. 2 parking brake wire assembly connector before performing this work.
Do not allow water, oil or dirt to enter the No. 2 parking brake wire assembly connector.

5. REMOVE PARKING BRAKE ACTUATOR ASSEMBLY

(a) Using a 5 mm hexagon socket wrench, remove the 2 bolts and parking brake actuator assembly from the rear disc brake cylinder assembly.

NOTICE:

Check that there are no brake fluid leaks from the back of the rear disc brake cylinder assembly.
If there are any brake fluid leaks, replace the rear disc brake cylinder assembly.

(b) Remove the O-ring from the rear disc brake cylinder assembly.

Inspection

INSPECTION PROCEDURE 1. INSPECT PARKING BRAKE ACTUATOR ASSEMBLY (a) Parking brake actuator assembly LH operation inspection (1) Apply voltage to the terminals of the parking brake actua ...

Installation

INSTALLATION CAUTION / NOTICE / HINT HINT: Use the same procedure for the RH side and LH side. The following procedure is for the LH side. PROCEDURE 1. INSTALL PARKING BRAKE ACT ...

Other materials:

Toyota CH-R Service Manual > Ambient Light: Inspection
INSPECTION PROCEDURE 1. INSPECT NO. 1 INTERIOR ILLUMINATION LIGHT ASSEMBLY LH (a) Check that the LED illuminates. (1) Apply battery voltage to the No. 1 interior illumination light assembly LH and check that the LED illuminates. OK: Measurement Condition ...

Toyota CH-R Service Manual > Tire Pressure Warning System: Registration
REGISTRATION PROCEDURE 1. BEFORE REGISTRATION NOTICE: The transmitter ID is written on the tire pressure warning valve and transmitter. It is not possible to read the transmitter ID after installing the tire onto the wheel. Therefore, make a note of the transmitter ID before installing the t ...

Toyota CH-R Service Manual: Removal

Inspection

Installation

Other materials:

Toyota C-HR (AX20) 2023-2025 Owner's Manual

Toyota CH-R Owners Manual

Toyota CH-R Service Manual