INSPECTION
PROCEDURE
1. INSPECT PARKING BRAKE ACTUATOR ASSEMBLY
(a) Parking brake actuator assembly LH operation inspection
|
(1) Apply voltage to the terminals of the parking brake actuator assembly and check that it operates as specified. Standard Resistance (LH Side):
If the result is not as specified, replace the parking brake actuator assembly LH. |
|
(b) Parking brake actuator assembly RH operation inspection
|
(1) Apply voltage to the terminals of the parking brake actuator assembly and check that it operates as specified. Standard Resistance (RH Side):
If the result is not as specified, replace the parking brake actuator assembly RH. |
|
On-vehicle Inspection
RemovalToyota CH-R Service Manual > Rear Coil Spring: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed and installed, or replaced during
rear coil spring removal/installation are shown below.
Necessary Procedures After Parts Removed/ ...
Toyota CH-R Service Manual > Continuously Variable Transaxle System: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Continuously Variable Transaxle System
DTC No.
Detection Item
MIL
Memory
Link
P0705
Transmission Range Sensor Circuit (PRNDL Input)
Comes on
DTC stored
...