Toyota CH-R Service Manual: Vsc Off Switch

Components

COMPONENTS

ILLUSTRATION

*1

VSC OFF SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)

-

-

Inspection

INSPECTION

PROCEDURE

1. INSPECT VSC OFF SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) (for LHD)

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

13 (+) - 8 (E)

Switch pushed

Below 1 Ω

13 (+) - 8 (E)

Switch not pushed

10 kΩ or higher

If the result is not as specified, replace the VSC OFF switch (electric parking brake switch assembly).

*a

Component without harness connected

(VSC OFF Switch (Electric Parking Brake Switch Assembly))

2. INSPECT VSC OFF SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY) (for RHD)

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

11 (+) - 8 (E)

Switch pushed

Below 1 Ω

11 (+) - 8 (E)

Switch not pushed

10 kΩ or higher

If the result is not as specified, replace the VSC OFF switch (electric parking brake switch assembly).

*a

Component without harness connected

(VSC OFF Switch (Electric Parking Brake Switch Assembly))

    VSC OFF Switch Circuit
    DESCRIPTION The skid control ECU assembly is connected to the combination meter assembly via CAN communication. Pressing the VSC OFF switch turns off TRAC operation, and pressing and holding thi ...

    Brake System (other)
    ...

    Other materials:

    Toyota CH-R Service Manual > Compressor(for Valeo Made): Installation
    INSTALLATION PROCEDURE 1. ADJUST COMPRESSOR OIL (a) When replacing the compressor with pulley assembly with a new one, gradually discharge the refrigerant gas from the service valve. Then drain the following amount of oil from the new compressor with pulley assembly before ...

    Toyota CH-R Service Manual > Washer Level Warning Switch: Installation
    INSTALLATION PROCEDURE 1. INSTALL LEVEL WARNING SWITCH ASSEMBLY (a) Install the level warning switch assembly as shown in the illustration. Install in this Direction (b) Connect the connector. 2. ADD WASHER FLUID Click here 3. INSTALL FRONT FENDER LINER RH ...

    Toyota C-HR (AX20) 2023-2025 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2025 Copyright www.tochr.net
    0.0161