Toyota CH-R Service Manual: Check For Intermittent Problems

Toyota CH-R Service Manual / Brake Control / Dynamic Control Systems / Vehicle Stability Control System / Check For Intermittent Problems

CHECK FOR INTERMITTENT PROBLEMS

CHECK FOR INTERMITTENT PROBLEMS

HINT:

A momentary interruption (open circuit) in the connectors and/or wire harness between the sensors and ECUs can be detected using the Data List function of the Techstream.

(a) Turn the ignition switch off.

(b) Connect the Techstream to the DLC3.

(c) Turn the ignition switch to ON.

(d) Turn the Techstream on.

(e) Follow the directions on the Techstream to display the Data List and select areas where momentary interruption should be monitored.

HINT:

  • A momentary interruption (open circuit) cannot be detected for 3 seconds after the ignition switch is turned to ON (initial check).
  • If Error remains displayed for one of the items on the Techstream, check for continuity between the ECU and the item for which Error is displayed.
  • If a momentary interruption occurs and Error is displayed on the Techstream, Error will remain displayed on the Techstream for 1 second after the circuit returns to normal.
Chassis > ABS/VSC/TRAC/EPB > Data List

Tester Display

Measurement Item

Range

Normal Condition

Diagnostic Note

EFI Communication Open

EFI communication open detection

Error or Normal

Error: Momentary interruption

Normal: Normal

-

Yaw Rate Open

Yaw rate sensor open detection

Error or Normal

Error: Momentary interruption

Normal: Normal

-

Deceleration Open

Acceleration sensor open detection

Error or Normal

Error: Momentary interruption

Normal: Normal

-

Steering Open

Steering angle sensor open detection

Error or Normal

Error: Momentary interruption

Normal: Normal

-

IG Voltage Value Decreased

+BS voltage value decrease detection

Error or Normal

Error: Voltage low

Normal: Normal

-

IG Voltage Value Increased

+BS voltage value increase detection

Error or Normal

Error: Voltage high

Normal: Normal

-

(f) While observing the screen, gently jiggle the connector or wire harness between the ECU and sensors, or between ECUs.

OK:

Normal is displayed.

HINT:

If the display changes, this indicates that there has been a momentary interruption (open circuit) in the connector and/or wire harness. In this case, repair or replace the connectors and/or wire harnesses as one of them is faulty.

    System Description
    SYSTEM DESCRIPTION FUNCTION DESCRIPTION (a) Enhanced-VSC (1) Effects cooperative control with the power steering ECU assembly in order to provide steering assist in accordance with the operating ...

    How To Proceed With Troubleshooting
    CAUTION / NOTICE / HINT HINT: *: Use the Techstream. PROCEDURE 1. VEHICLE BROUGHT TO WORKSHOP NEXT ...

    Other materials:

    Toyota CH-R Service Manual > Audio And Visual System(for Radio Receiver Type): Panel Switches do not Function
    PROCEDURE 1. CHECK PANEL SWITCH (a) Check for foreign matter around the switches that might prevent operation. OK: No foreign matter is found. OK PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE NG R ...

    Toyota CH-R Service Manual > Vehicle Stability Control System: SM Solenoid Circuit (C1225-C1228,C1468,C1469,C146A,C146B)
    DESCRIPTION These solenoids turn on when signals are received from the skid control ECU (brake actuator assembly) and they control the pressure acting on the wheel cylinders to control the braking force. DTC No. Detection Item DTC Detection Condition ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.009