Toyota CH-R Service Manual: Brake Hold Switch

Toyota CH-R Service Manual / Brake Control / Dynamic Control Systems / Brake Hold Switch

Components

COMPONENTS

ILLUSTRATION

*1

BRAKE HOLD SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)

-

-

Inspection

INSPECTION

PROCEDURE

1. INSPECT BRAKE HOLD SWITCH (ELECTRIC PARKING BRAKE SWITCH ASSEMBLY)

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

12 (+B) - 8 (E)

Switch pushed

Below 1 Ω

12 (+B) - 8 (E)

Switch not pushed

10 kΩ or higher

If the result is not as specified, replace the brake hold switch (electric parking brake switch assembly).

*a

Component without harness connected

(Brake Hold Switch (Electric Parking Brake Switch Assembly))
    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during th ...

    Front Speed Sensor
    ...

    Other materials:

    Toyota CH-R Service Manual > Blower Unit(for Valeo Made): Components
    COMPONENTS ILLUSTRATION *A for Dual Type *B for Single Type *C w/ PTC Heater - - *1 BLOWER ASSEMBLY *2 NO. 2 AIR DUCT *3 NO. ...

    Toyota CH-R Service Manual > Power Mirror Control System: Precaution
    PRECAUTION IGNITION SWITCH EXPRESSIONS (a) The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ignition Switch (Position) Engine Swi ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0067