DESCRIPTION
The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
C1A45 |
Vehicle Speed Sensor |
A fail flag is transmitted from the skid control ECU |
|
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
PROCEDURE
|
1. |
CHECK OTHER DTC OUTPUT (VEHICLE STABILITY CONTROL SYSTEM) |
(a) Check for vehicle stability control system DTCs.
Click here
OK:
Vehicle stability control system DTCs are not output.
| NG | |
GO TO VEHICLE STABILITY CONTROL SYSTEM
|
|
|
2. |
CHECK DTC |
(a) Turn the ignition switch off.
(b) Turn the ignition switch to ON.
(c) Recheck for DTCs and check if the same DTC is output again.
Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes|
Result |
Proceed to |
|---|---|
|
No DTCs are output. |
A |
|
DTC C1A45 is output ("Blind Spot Monitor Master"). |
B |
|
DTC C1A45 is output ("Blind Spot Monitor Slave"). |
C |
| A | |
USE SIMULATION METHOD TO CHECK
|
| B | |
REPLACE BLIND SPOT MONITOR SENSOR LH (MASTER) |
| C | |
REPLACE BLIND SPOT MONITOR SENSOR RH (SLAVE) |
Steering Angle Sensor (C1A47)
Yaw Rate Sensor (C1A46)Toyota CH-R Service Manual > Name Plate: Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
When installing the name plates, heat the back door outside garnish and name
plates using a heat light.
Heating Temperature
Item
Temperature
Back Door Outside Garnish
Name Plate
...
Toyota CH-R Service Manual > Window Defogger System: Rear Window Defogger System does not Operate
DESCRIPTION
When the rear window defogger switch on the air conditioning control assembly
is pressed, the operation signal is transmitted to the air conditioning amplifier
assembly via LIN communication. When the air conditioning amplifier assembly receives
the signal, it turns on the DEF rel ...