DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the blind spot monitor system on.
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes.
HINT:
The blind spot monitor sensor RH (Slave) and the blind spot monitor sensor LH (Master) both output DTCs. Therefore, check both blind spot monitor sensors for DTCs.
Body Electrical > Blind Spot Monitor Master > Trouble Codes Body Electrical > Blind Spot Monitor Slave > Trouble Codes(f) Check for DTCs.
Click here
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the blind spot monitor system on.
(d) Turn the Techstream on.
(e) Enter the following menus: Body Electrical / Blind Spot Monitor Master or Blind Spot Monitor Slave / Trouble Codes.
Body Electrical > Blind Spot Monitor Master > Clear DTCs Body Electrical > Blind Spot Monitor Slave > Clear DTCs(f) Clear the DTCs.
Terminals Of Ecu
Freeze Frame DataToyota CH-R Owners Manual > Engine compartment: Washer fluid
Add washer fluid in the following situations:
A washer does not work.
The warning message appears on the multi-information display (if equipped).
The washer fluid level is extremely low (type A) or at "LOW" (type B).
Type A
Raise the cap keeping your finger pressed down ...
Toyota CH-R Service Manual > Airbag System: Short in Side Squib RH Circuit (B1820/55-B1823/55)
DESCRIPTION
The side squib RH circuit consists of the airbag sensor assembly and front seat
airbag assembly RH.
The airbag sensor assembly uses this circuit to deploy the airbag when deployment
conditions are met.
These DTCs are stored when a malfunction is detected in the side squib RH circu ...