DESCRIPTION
This DTC is set when an error in the EEPROM or PLL IC is detected on the DCM (Telematics Transceiver) self-check. The EEPROM (Electrically Erasable Programmable Read-Only Memory) stores the various data to operate the safety connect system. The PLL IC (Phase-Locked Loop Integrated Circuit) oscillates telephone radio frequency.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
B15A8 |
Telematics Transceiver Malfunction |
Error in EEPROM or PLL IC is detected. |
DCM (Telematics Transceiver) |
CAUTION / NOTICE / HINT
NOTICE:
Regardless of whether DTC B15A8 has been output as a present or history DTC, the DCM (Telematics Transceiver) should be replaced.
PROCEDURE
|
1. |
REPLACE DCM (TELEMATICS TRANSCEIVER) |
(a) Replace the DCM (Telematics Transceiver).
Click here
NOTICE:
| NEXT | |
PERFORM DCM ACTIVATION |
Diagnostic Trouble Code Chart
Short in Telephone Antenna Circuit (B1573,B15CB)Toyota CH-R Service Manual > Shift Lever: Inspection
INSPECTION
PROCEDURE
1. INSPECT SHIFT LOCK CONTROL UNIT ASSEMBLY (w/o Smart Key System)
HINT:
If the results of the following inspections are as specified but a malfunction
has occurred, replace the shift lock control unit assembly.
(a) Inspect the wire harness.
(1) Disconnect the ...
Toyota CH-R Service Manual > Repair Instruction: Initialization
INITIALIZATION
PROCEDURES NECESSARY WHEN BATTERY TERMINAL IS DISCONNECTED/RECONNECTED
Necessary Procedures
Effect/Inoperative Function when Necessary Procedures not Performed
Link
Initialize back door lock
Power door lock control system
...