ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT RADIO SETTING CONDENSER
(a) With the radio setting condenser installed, check that there is no looseness or other abnormalities.
|
(b) Measure the resistance of the radio setting condenser according to the value(s) in the table below. Standard Resistance:
|
|
(c) Remove the bolt.
(d) Disengage the clamp and disconnect the radio setting condenser with wire harness from the vehicle body.
|
(e) Measure the resistance and voltage of the radiosetting condenser according to the value(s) in the table below. Standard Resistance:
Standard Voltage:
|
|
Components
RemovalToyota CH-R Service Manual > Immobiliser System(w/o Smart Key System): Transponder Chip Malfunction (B2793,B2794,B2797,B2798)
DESCRIPTION
DTC B2793 is stored when a malfunction is found in the key during key
ID code registration or a key ID code is not registered normally. Replace
the key if key ID code registration cannot be performed normally and this
DTC is output.
DTC B2794 is stored when a key ...
Toyota CH-R Service Manual > Navigation System: Touch Panel Switch does not Function
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or
maintenance, performing initialization, registration or calibration may
be needed. Refer to Precaution for Navigation System.
Click here
When replacing the radio ...