Toyota CH-R Service Manual: Voice is not Recognized

PROCEDURE

1.

CHECK CONDITION

(a) While paying attention to the condition of the spoken voice command, perform a voice recognition operation.

OK:

Voice command is recognized normally.

HINT:

  • When the voice command is recognized, the content of the voice command is displayed in the voice recognition result display area to the right of the mic icon. (Example: When "Cancel" is spoken, "Cancel" is displayed in the voice recognition result display area.)
  • If an unnecessary word (such as "um" or "ah") is spoken before or after the recognition word, the system incorrectly recognizes the recognition word.
  • The system cannot recognize voice commands when multiple people are speaking simultaneously.
  • If the speaking speed is too fast or too slow, the recognition rate may decrease.
  • The system may have difficulty recognizing voice commands depending on the voice quality (such as a hoarse voice due to poor physical condition).
OK

END (VOICE RECOGNITION MAY BE DIFFICULT DUE TO SPEECH CONDITION)

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    Cellular Phone Registration Failure
    CAUTION / NOTICE / HINT NOTICE: Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be neede ...

    Cellular Phone Inspection
    PROCEDURE 1. CHECK USAGE CONDITION (a) Check that the vehicle and cellular phone meet the following conditions: NOTICE: If changing cellular phone settings, updatin ...

    Other materials:

    Toyota CH-R Service Manual > Smart Key System(for Start Function): ACC Monitor Malfunction (B2274)
    DESCRIPTION This DTC is stored when a malfunction in the ACC output circuit is detected. The ACC output circuit is the circuit between terminal ACCD of the certification ECU (smart key ECU assembly) and the ACC relay. DTC No. Detection Item DTC Detection Condit ...

    Toyota CH-R Service Manual > Vacuum Pump: Reassembly
    REASSEMBLY PROCEDURE 1. INSTALL VACUUM PUMP VANE (a) Apply engine oil to the vacuum pump vane and 2 vacuum pump vane caps. (b) Install the vacuum pump vane caps to the vacuum pump vane. NOTICE: When reusing the vacuum pump vane and vacuum pump vane caps, install them in the ...

    © 2017-2020 Copyright www.tochr.net
    0.0161