Toyota CH-R Service Manual: No Sound can be Heard from Speakers

PROCEDURE

1.

CHECK AUDIO SETTINGS

(a) In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal.

OK:

Audio system returns to normal.

HINT:

Sound quality adjustment measures vary according to the type of amplifier.

OK

END

NG

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

    Satellite Radio Broadcast cannot be Selected or After Selecting Broadcast, Broadcast cannot be Added into Memory
    CAUTION / NOTICE / HINT NOTICE: Some satellite radio broadcasts require payment. A contract must be made between a satellite radio company and the user. If the contract expires, it will not be p ...

    Noise Occurs
    PROCEDURE 1. CHECK NOISE CONDITION (a) Check from which direction the noise comes (front left or right, or rear left or right). OK: The location of the noise sou ...

    Other materials:

    Toyota CH-R Service Manual > Blower Unit(for Denso Made): Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during blower unit removal/installation are shown below. Necessary Procedure After Parts Removed/Install ...

    Toyota CH-R Service Manual > Continuously Variable Transaxle System: Torque Converter Clutch Solenoid Circuit Low (P2769,P2770)
    DESCRIPTION Based on the signal received by the shift solenoid valve SL, the ECM uses the shift solenoid valve SLU to control the lock-up clutch pressure. If there is an open or short in the shift solenoid valve SL circuit, the ECM stops sending current to the defective shift solenoid valve. ...

    © 2017-2021 Copyright www.tochr.net
    0.0174