DESCRIPTION
This DTC is stored when items controlled by the air conditioning amplifier assembly cannot be customized via the audio and visual system vehicle customization screen.
HINT:
The air conditioning amplifier assembly controls the air conditioning system related items that are customizable via the audio and visual system vehicle customization screen.
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
---|---|---|---|
B15F5 |
Air Conditioner ECU Vehicle Information Reading/Writing Processor Malfunction |
Air conditioning amplifier assembly vehicle setting processing malfunction |
|
CAUTION / NOTICE / HINT
NOTICE:
When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
PROCEDURE
1. |
CHECK CAN COMMUNICATION SYSTEM |
(a) Use the Techstream to check if the CAN communication system is functioning normally.
Click here
OK:
CAN communication DTCs are not output.
NG | ![]() |
GO TO CAN COMMUNICATION SYSTEM |
|
2. |
CHECK AIR CONDITIONING SYSTEM |
(a) Check if the air conditioning system is malfunctioning.
HINT:
Customization may not be possible depending on the malfunction in the air conditioning system.
OK:
No malfunctions are present in the air conditioning system.
NG | ![]() |
GO TO AIR CONDITIONING SYSTEM (for Automatic Air Conditioning System with Top-mounted Air Conditioner Pressure Sensor) |
|
3. |
CHECK CUSTOMIZE ITEMS (for Automatic Air Conditioning System with Top-mounted Air Conditioner Pressure Sensor) |
(a) Make a note of the customizable items for the air conditioning system.
HINT:
The items shown as customizable via the audio and visual system vehicle customization screen can also be changed using the Techstream. In the following step, the Techstream will be used.
(1) To match-up the items on the audio and visual system vehicle customization screen with the items on the Techstream, check the customize parameters list for the air conditioning system related items that can be customized via the audio and visual system vehicle customization screen.
Click here
(b) Using the Techstream, confirm that it is possible to change the settings of the customize parameters that are available for customization via the audio and visual system vehicle customization screen.
OK:
The items available for customization via the audio and visual system vehicle customization screen can be customized successfully using the Techstream.
OK | ![]() |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
NG | ![]() |
REPLACE AIR CONDITIONING AMPLIFIER ASSEMBLY |
Toyota CH-R Service Manual > Power Window Regulator Motor(for Rear Door): Components
COMPONENTS
ILLUSTRATION
*1
REAR DOOR BELT REAR SEAL
*2
REAR DOOR BELT SEAL
*3
REAR DOOR GLASS INNER WEATHERSTRIP
*4
REAR DOOR INSIDE HANDLE BEZEL PLUG
*5
REAR DOOR REAR FRAME ...
Toyota CH-R Service Manual > Power Window Control System: Terminals Of Ecu
TERMINALS OF ECU
CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
(a) Disconnect the J6 multiplex network master switch assembly connector.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
HINT:
Measure the values on the wire harness side with the connector ...