Toyota CH-R Service Manual: Precaution

NOTICE:

• When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
  • A communication malfunction DTC is stored.
  • The radio and display receiver assembly may not operate normally.
• When replacing the DCM (telematics transceiver), make sure to replace it with a new one.*1
• After replacing the navigation ECU, if "New software is not compatible with the system. Contact your dealer." is displayed on the multi-display, update the software of the radio and display receiver assembly.

• *1: w/ Manual (SOS) Switch

• Radio and display receiver assembly*1
• DCM (telematics transceiver)*2

• *1: After replacing the radio and display receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, SiriusXM radio ID registration is necessary (w/ SXM Function).

  *2: w/ Manual (SOS) Switch

Audio And Visual System(for Radio And Display Type)

...

Parts Location

PARTS LOCATION ILLUSTRATION *1 MAP LIGHT ASSEMBLY (TELEPHONE MICROPHONE ASSEMBLY) *2 SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) ILLUSTRATION ...

Other materials:

Toyota CH-R Service Manual > Airbag System: Manual Cut off Switch Trouble (B1651/33)
DESCRIPTION The airbag cut off switch circuit consists of the airbag sensor assembly and airbag cut off switch cylinder sub-assembly. The instrument panel passenger without door airbag assembly can be optionally deactivated via this circuit by turning the airbag cut off switch cylinder sub-ass ...

Toyota CH-R Service Manual > Front Lower Suspension Arm: Installation
INSTALLATION PROCEDURE 1. INSTALL FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY (a) Temporarily install the front lower No. 1 suspension arm sub-assembly LH to the front suspension crossmember sub-assembly with the 2 bolts and nut. (b) Install the front lower No. 1 suspension arm sub-assembly ...