CAUTION / NOTICE / HINT
HINT:
If the operation of a cellular phone or the radio receiver assembly is requested, make sure to follow the instructions closely and perform the operation.
PROCEDURE
1. |
CHECK USAGE CONDITION |
(a) Check that the vehicle and cellular phone meet the following conditions:
NOTICE:
If changing cellular phone settings, updating software, etc. is necessary, make sure to obtain the permission of the customer before performing it.
Click here
(b) Register the cellular phone again and check if it is registered correctly.
HINT:
If the operation of a cellular phone or the radio receiver assembly is requested, make sure to follow the instructions closely and perform the operation.
Result |
Proceed to |
---|---|
Cellular phone can be registered. |
A |
Cellular phone cannot be registered. |
B |
A | ![]() |
END |
|
2. |
RESTART CELLULAR PHONE |
(a) Restart the cellular phone.
(b) Turn the ignition switch off.
(c) Turn the ignition switch to ACC.
(d) Register the cellular phone as a connected device again and check if it is registered correctly.
HINT:
If the operation of a cellular phone or the radio receiver assembly is requested, make sure to follow the instructions closely and perform the operation.
Result |
Proceed to |
---|---|
Cellular phone can be registered. |
A |
Cellular phone cannot be registered. |
B |
A | ![]() |
END |
|
3. |
CHECK BRING CELLULAR PHONE NEAR IN-VEHICLE DEVICE |
(a) Place the cellular phone close to the radio receiver assembly.
(b) Register the cellular phone as a connected device again and check if it is registered correctly.
HINT:
If the operation of a cellular phone or the radio receiver assembly is requested, make sure to follow the instructions closely and perform the operation.
Result |
Proceed to |
---|---|
Cellular phone can be registered. |
A |
Cellular phone cannot be registered. |
B |
A | ![]() |
END |
|
4. |
CLEAR REGISTERED DEVICE INFORMATION |
(a) Clear all "Bluetooth" devices registered to the cellular phone and radio receiver assembly.
(b) Register the cellular phone as a connected device again and check if it is registered correctly.
HINT:
If the operation of a cellular phone or the radio receiver assembly is requested, make sure to follow the instructions closely and perform the operation.
Result |
Proceed to |
---|---|
Cellular phone can be registered. |
A |
Cellular phone cannot be registered. |
B |
A | ![]() |
END |
|
5. |
CHECK USING ANOTHER VEHICLE |
(a) Check if the cellular phone can be registered normally to another "Bluetooth" audio compatible vehicle of the same model.
HINT:
Result |
Proceed to |
---|---|
Cellular phone can be registered. |
A |
Cellular phone cannot be registered. |
B |
A | ![]() |
REPLACE RADIO RECEIVER ASSEMBLY |
|
6. |
CHECK USING ANOTHER CELLULAR PHONE |
(a) Using another "Bluetooth" compatible cellular phone, register the cellular phone and check that it is registered correctly.
HINT:
Result |
Proceed to |
---|---|
Cellular phone can be registered. |
A |
Cellular phone cannot be registered. |
B |
A | ![]() |
END (ONLY A "Bluetooth" COMPATIBLE CELLULAR PHONE CAN BE USED) |
B | ![]() |
REPLACE RADIO RECEIVER ASSEMBLY |
Toyota CH-R Service Manual > Rear Brake(for Tmmt Made): Reassembly
REASSEMBLY
PROCEDURE
1. TEMPORARILY TIGHTEN REAR DISC BRAKE BLEEDER PLUG
(a) Temporarily install the rear disc brake bleeder plug to the rear disc brake
cylinder assembly.
HINT:
Fully tighten the rear disc brake bleeder plug after bleeding the system.
2. INSTALL REAR DISC BRAKE BLEEDER PLUG ...
Toyota CH-R Service Manual > Electric Parking Brake Actuator: Precaution
PRECAUTION
IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs depending on the specifications
of the vehicle. The expressions listed in the table below are used in this section.
Expression
Ignition Switch (Position)
Engine Swi ...