Toyota CH-R Service Manual: Diagnosis System

DIAGNOSIS SYSTEM

DESCRIPTION

(a) Smart key system (for Entry Function) data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3). In some cases, a malfunction may be occurring in the smart key system. When the system seems to be malfunctioning, use the Techstream to check for malfunctions and perform repairs.

CHECK DLC3

(a) Check the DLC3.

Click here

INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery.

    Terminals Of Ecu
    TERMINALS OF ECU CHECK CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (a) Disconnect the F1 certification ECU (smart key ECU assembly) connector. (b) Measure the voltage and resistance according to t ...

    Dtc Check / Clear
    DTC CHECK / CLEAR CHECK FOR DTC NOTICE: When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 se ...

    Other materials:

    Toyota CH-R Service Manual > Curtain Shield Airbag Assembly: Disposal
    DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre-disposal deployment may be considered hazardous material treatment. PROCEDURE 1. PRECAUTION ...

    Toyota CH-R Service Manual > Smart Key System(for Start Function): System Voltage or GND Energization Malfunction (B228B)
    DESCRIPTION This DTC is stored when there is a malfunction in the certification ECU (smart key ECU assembly) battery power supply circuit or ground circuit. DTC No. Detection Item DTC Detection Condition Trouble Area Note B2 ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0104