The multi-information display presents the driver with a variety of vehicle data.
Displays the following information when an icon is selected.
Some of the information may be displayed automatically depending on the situation.
Drive information
Select to display various drive data.
Navigation system-linked display (if equipped)
Audio system-linked display
Select to enable selection of an audio source or track on the meter using the meter control switches.
Driving assist system information
Select to display the operational status of the following systems:
LDA (Lane Departure Alert)
Dynamic radar cruise control with full-speed range
Warning message display
Select to display warning messages and measures to be taken if a malfunction is detected.
Settings display
Select to change the meter display settings and the operation settings of some vehicle functions.
Operating the meter control switches
The multi-information display is operated using the meter control switches.
Drive information
Displays the current rate of fuel consumption.
Displays the average fuel consumption since the function was reset, the engine was started, and the vehicle was refueled, respectively.
Use the displayed average fuel consumption as a reference.
Displays the average vehicle speed since the function was reset and the engine was started, respectively
Displays the elapsed time since the function was reset and the engine was started, respectively
Displays the estimated maximum distance that can be driven with the quantity of fuel remaining and the distance driven after the engine was started, respectively
- This distance is computed based on your average fuel consumption. As a result, the actual distance that can be driven may differ from that displayed.
- When only a small amount of fuel is added to the tank, the display may not be updated.
When refueling, turn the engine switch off. If the vehicle is refueled without turning the engine switch off, the display may not be updated.
Displays the vehicle speed.
Detects the sway of the vehicle within a lane, which is often associated with a decrease in the driver's attention level, and displays the decrease in attention using a bar display.
The shorter the bar length, the more the driver may need to rest.
This display is a part of the LDA (Lane Departure Alert with steering control).
The display is enabled when the operating conditions of the vehicle sway warning are met.
A blank screen is displayed.
*1: Can be registered to Drive information 1 and 2.
*2: Resetting procedures:
- Select a function to be reset using the meter control switches and then press and hold to reset.
- If there is more than one function that can be reset, check boxes will be displayed next to those functions.
Navigation system-linked display (if equipped)
Displays the following items, which are linked to the navigation system:
■ Street name When the navigation system is performing route guidance, the name of the next street will be displayed on the top of the display area.
■ Route guidance to destination Displayed when the navigation system is performing route guidance.
When approaching an intersection, an arrow will be displayed to indicate the suggested direction of travel.
■ Compass Displays the direction of travel.
Toyota CH-R Service Manual > Vehicle Stability Control System: Master Cylinder Pressure Sensor Malfunction (C1246)
DESCRIPTION
The master cylinder pressure sensor is connected to the skid control ECU in the
brake actuator assembly.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1246
Master Cylinder Pressure Sensor Malfunc ...
Toyota CH-R Service Manual > Wheel Opening Moulding(for Rear): Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. INSTALL QUARTER OUTSIDE MOULDING
HINT:
When installing the quarter outside moulding, heat the vehicle body and quarter
ou ...