Toyota CH-R Service Manual: Diagnosis System

DIAGNOSIS SYSTEM

DESCRIPTION

(a) The transponder key ECU assembly controls the immobiliser system. Immobiliser system data and Diagnostic Trouble Codes (DTCs) can be read through the vehicle Data Link Connector 3 (DLC3).

CHECK DLC3

(a) Check the DLC3.

Click here

INSPECT BATTERY VOLTAGE

(a) Measure the battery voltage.

Standard Voltage:

11 to 14 V

If the voltage is below 11 V, recharge or replace the battery.

    Terminals Of Ecu
    TERMINALS OF ECU CHECK TRANSPONDER KEY ECU ASSEMBLY (a) Disconnect the F22 transponder key ECU assembly connector. (b) Measure the resistance and voltage according to the value(s) in the table ...

    Dtc Check / Clear
    DTC CHECK / CLEAR CHECK FOR TRANSPONDER KEY ECU ASSEMBLY DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: ...

    Other materials:

    Toyota CH-R Service Manual > Power Door Lock Control System: System Diagram
    SYSTEM DIAGRAM Power Door Lock Control System Communication Table Sender Receiver Signal Line Multiplex Network Master Switch Assembly Main Body ECU (Multiplex Network Body ECU) Door control switch signal ...

    Toyota CH-R Service Manual > Lighting System: Diagnostic Trouble Code Chart
    DIAGNOSTIC TROUBLE CODE CHART Lighting System DTC No. Detection Item Note Link B1244 Light Sensor Circuit Malfunction - B242C Right Headlight ECU Malfunction ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0077