Toyota CH-R Service Manual: On-vehicle Inspection

ON-VEHICLE INSPECTION

CAUTION / NOTICE / HINT

CAUTION:

Be sure to correctly follow the removal and installation procedures for the front seat cushion airbag assembly RH.

PROCEDURE

1. INSPECT FRONT SEAT CUSHION AIRBAG ASSEMBLY RH (for Vehicle not Involved in Collision)

(a) Perform a diagnostic system check.

Click here

(b) Visually check for defects with the front seat cushion airbag assembly RH installed to the vehicle.

HINT:

The defects are as follows:

  • Scratches, broken or frayed threads on the surface of the front seat cushion assembly around the front seat cushion airbag assembly RH
  • Small cracks on the front seat cushion assembly around the front seat cushion airbag assembly RH
  • Significant discoloration on the front seat cushion assembly around the front seat cushion airbag assembly RH

OK:

No defects are found.

If any defects are found, replace the separate type front seat cushion pad or separate type front seat cushion cover with a new one.

2. INSPECT FRONT SEAT CUSHION AIRBAG ASSEMBLY RH (for Vehicle Involved in Collision and Airbag not Deployed)

(a) Perform a diagnostic system check.

Click here

(b) Visually check for defects with the front seat cushion airbag assembly RH removed from the vehicle.

HINT:

The defects are as follows:

  • Cuts
  • Small cracks
  • Significant discoloration
  • Marks from being dropped
  • Cracks or other damage to the wire harness or connector
  • Deformation of the installation surface of the front seat cushion airbag assembly RH

OK:

No defects are found.

If any defects are found, replace the front seat cushion airbag assembly RH with a new one.

    Components
    COMPONENTS ILLUSTRATION *1 FRONT SEAT CUSHION AIRBAG ASSEMBLY RH - - Tightening torque for "Major areas involving basic v ...

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during th ...

    Other materials:

    Toyota CH-R Service Manual > General Maintenance: Body
    BODY TIGHTEN BOLTS AND NUTS ON CHASSIS AND BODY (a) If necessary, tighten the bolts and nuts on the chassis parts listed below. Front axle and suspension Drivetrain Rear axle and suspension Brake system Engine mounts Other chassis parts (b) If necessary, tighten ...

    Toyota CH-R Service Manual > Introduction: Identification Information
    Vehicle Identification And Serial Numbers VEHICLE IDENTIFICATION AND SERIAL NUMBERS VEHICLE IDENTIFICATION NUMBER (a) The vehicle identification number is stamped on the vehicle body and on the name label as shown in the illustration. *1 Vehicle Identification Number ...

    © 2017-2021 Copyright www.tochr.net
    0.0155