ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the seat position airbag sensor.
PROCEDURE
1. INSPECT SEAT POSITION AIRBAG SENSOR (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here
2. INSPECT SEAT POSITION AIRBAG SENSOR (for Vehicle Involved in Collision)
(a) Perform a diagnostic system check.
Click here
(b) Visually check for defects with the seat position airbag sensor removed from the vehicle.
HINT:
The defects are as follows:
OK:
No defects are found.
If any defects are found, replace the seat position airbag sensor with a new one.
Components
RemovalToyota CH-R Service Manual > Transmission Control Cable: Installation
INSTALLATION
PROCEDURE
1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
(a) Pass the transmission control cable assembly into the vehicle and
install the transmission control cable assembly to the vehicle body with
the 2 nuts.
Torque:
5.0 N·m {51 kgf·cm, 44 in·lbf}
...
Toyota CH-R Service Manual > Windshield Outside Moulding: Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. REMOVE WINDSHIELD OUTSIDE MOULDING
(a) Apply protective tape around the windshield outside moulding.
Prote ...