ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the No. 2 side airbag sensors.
PROCEDURE
1. INSPECT NO. 2 SIDE AIRBAG SENSOR (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Click here
2. INSPECT NO. 2 SIDE AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag not Deployed)
(a) Perform a diagnostic system check.
Click here
(b) Visually check the No. 2 side airbag sensors for defects if a quarter panel of the vehicle or the area around a quarter panel is damaged.
HINT:
The defects are as follows:
OK:
No defects are found.
If any defects are found, replace the No. 2 side airbag sensor with a new one.
3. INSPECT NO. 2 SIDE AIRBAG SENSOR (for Vehicle Involved in Collision and Airbag is Deployed)
(a) When airbags have deployed as the result of a collision, be sure to replace all No. 2 side airbag sensors in the damaged areas (anywhere in need of repair).
(b) Visually check the No. 2 side airbag sensors in undamaged areas for defects.
HINT:
The defects are as follows:
OK:
No defects are found.
If any defects are found or a No. 2 side airbag sensor has detected a major collision, replace the No. 2 side airbag sensor with a new one.
Toyota CH-R Service Manual > Blind Spot Monitor System: Parts Location
PARTS LOCATION
ILLUSTRATION
*1
OUTER REAR VIEW MIRROR ASSEMBLY LH
*2
OUTER REAR VIEW MIRROR ASSEMBLY RH
*3
BRAKE ACTUATOR ASSEMBLY
- SKID CONTROL ECU
*4
ECM
ILLUSTRATION
*1
...
Toyota CH-R Service Manual > Immobiliser System(w/o Smart Key System): Theft Deterrent System Presence Detection (B279C)
DESCRIPTION
If an ECM that is incompatible with the immobiliser system is installed, the
ECM stores this DTC.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
Note
B279C
Theft Deterrent System Presence ...