Toyota CH-R Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the driver side and front passenger side.
  • The procedure listed below is for the driver side.

PROCEDURE

1. INSTALL FRONT SEAT AIRBAG ASSEMBLY

(a) Install the front seat airbag assembly with 2 new nuts.

Torque:

5.5 N·m {56 kgf·cm, 49 in·lbf}

NOTICE:

  • Do not reuse the nuts.
  • Make sure that the front seatback frame sub-assembly is not deformed. If it is deformed, replace it with a new one.

(b) Engage the clamp.

2. INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

Click here

    Disposal
    DISPOSAL CAUTION / NOTICE / HINT CAUTION: Before performing pre-disposal deployment of any SRS part, review and closely follow all applicable environmental and hazardous material regulations. Pre ...

    Knee Airbag Assembly
    ...

    Other materials:

    Toyota CH-R Service Manual > Immobiliser System(w/ Smart Key System): Short to GND in Immobiliser System Power Source Circuit (B278A)
    DESCRIPTION When there is a short to GND in the power supply for the transponder key amplifier of the engine switch, the certification ECU (smart key ECU assembly) stores this DTC. DTC No. Detection Item DTC Detection Condition Trouble Area ...

    Toyota CH-R Service Manual > Air Conditioning System(for Automatic Air Conditioning System With Side-mounted Air Conditioner Pressure Sensor): Compressor Solenoid Circuit (B1451)
    DESCRIPTION In this circuit, the cooler compressor assembly (compressor solenoid) receives a refrigerant compression demand signal from the air conditioning amplifier assembly. Based on this signal, the cooler compressor assembly (compressor solenoid) changes the amount of compressor output. ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0117