Toyota CH-R Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

CAUTION:

  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

HINT:

Front lumbar power seat switch is available only on the driver side.

PROCEDURE

1. INSTALL FRONT LUMBAR POWER SEAT SWITCH

(a) Engage the guides to install the front lumber power seat switch.

(b) Install the 2 screws.

2. INSTALL FRONT SEAT CUSHION SHIELD

Click here

3. INSTALL SEAT ADJUSTER COVER CAP

Click here

4. INSTALL RECLINING ADJUSTER RELEASE HANDLE

Click here

5. INSTALL RECLINING HINGE OUTER COVER

Click here

6. INSTALL VERTICAL ADJUSTING HANDLE

Click here

7. CONNECT SEPARATE TYPE FRONT SEATBACK COVER

Click here

8. INSTALL FRONT SEAT ASSEMBLY

Click here

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during th ...

    Rear Seat Assembly
    ...

    Other materials:

    Toyota CH-R Service Manual > Toyota Entune System: Problem Symptoms Table
    PROBLEM SYMPTOMS TABLE NOTICE: The following may occur if a radio and display receiver assembly from another vehicle is installed to this vehicle. Therefore, when replacing the radio and display receiver assembly, be sure to replace it with a new one. A communicat ...

    Toyota CH-R Service Manual > Brake Pedal: Adjustment
    ADJUSTMENT PROCEDURE 1. INSPECT AND ADJUST BRAKE PEDAL HEIGHT (a) Remove the No. 1 air duct. Click here (b) Check the brake pedal height. NOTICE: Inspect and adjust the brake pedal height with the floor carpet folded back. When performing the measurement, make sure that th ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.012