Toyota CH-R Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT FRONT LUMBAR POWER SEAT SWITCH

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

5 (H) - 2 (B)

Front lumbar power seat (Hold) pressed

Below 1 Ω

3 (R) - 4 (E)

5 (H) - 4 (E)

Off

3 (R) - 4 (E)

3 (R) - 2 (B)

Front lumbar power seat (Release) pressed

5 (H) - 4 (E)

If the result is not as specified, replace the front lumbar power seat switch.

*a

Front Lumbar Power Seat (Release)

*b

Front Lumbar Power Seat (Hold)

*c

Component without harness connected

(Front Lumbar Power Seat Switch)

    Components
    COMPONENTS ILLUSTRATION *1 FRONT SEAT CUSHION SHIELD *2 RECLINING ADJUSTER RELEASE HANDLE *3 RECLINING HINGE OUTER COVER ...

    Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during th ...

    Other materials:

    Toyota CH-R Service Manual > Rain Sensor: Removal
    REMOVAL PROCEDURE 1. REMOVE RAIN SENSOR COVER (a) Release the stopper by pulling it out as shown in the illustration. *a Stopper Release Remove in this Direction (b) Disconnect the rain sensor with rain sensor ...

    Toyota CH-R Service Manual > Steering Gear: Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during steering gear assembly removal/installation are shown below. Necessary Procedures After Parts Re ...

    Toyota C-HR (AX20) 2023-2025 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2025 Copyright www.tochr.net
    0.0101