Toyota CH-R Service Manual: Removal

REMOVAL

CAUTION / NOTICE / HINT

NOTICE:

  • Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attention to the surroundings.
  • Immediately after installing the front disc brake pads, the brake pedal may feel soft due to clearance between the front disc brake pads and front disc. Depress the brake pedal several times until the brake pedal feels firm.

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. REMOVE FRONT WHEEL

Click here

2. REMOVE FRONT DISC BRAKE PAD

CAUTION:

  • After lifting up the front disc brake cylinder assembly, secure it in place before performing any work on it.
  • The front disc brake cylinder assembly could fall, pinching hands or fingers and causing injury.

(a) Hold the front disc brake cylinder slide pin (lower side) and remove the bolt.

NOTICE:

Do not kink or damage the brake line.

*a

Turn

*b

Hold

(b) Pull the front disc brake cylinder assembly upward.

(c) Remove the 2 front disc brake pads from the front disc brake cylinder mounting.

3. REMOVE FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT

(a) Remove the front No. 1 disc brake anti-squeal shim and front No. 2 disc brake anti-squeal shim from each front disc brake pad.

(b) Remove the 2 front brake pad radial springs from each front disc brake pad.

    Components
    COMPONENTS ILLUSTRATION *1 FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT *2 FRONT DISC BRAKE CYLINDER ASSEMBLY *3 FRONT DISC BRAKE P ...

    Installation
    INSTALLATION CAUTION / NOTICE / HINT NOTICE: Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying ...

    Other materials:

    Toyota CH-R Service Manual > Rear Trailing Arm: Components
    COMPONENTS ILLUSTRATION *1 NO. 2 PARKING BRAKE WIRE ASSEMBLY *2 REAR STABILIZER LINK ASSEMBLY *3 REAR TRAILING ARM ASSEMBLY *4 REAR STABILIZER BAR Tightening torque for "M ...

    Toyota CH-R Service Manual > Charging System: Charging Failure
    PROCEDURE 1. CHECK GENERATOR PULLEY WITH CLUTCH (ON-VEHICLE INSPECTION) (a) Start the engine and visually check that the generator rotor assembly (fan) in the generator assembly is operating. OK: The generator rotor assembly (fan) is operating. NG ...

    Toyota C-HR (AX20) 2023-2025 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2025 Copyright www.tochr.net
    0.0129