PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
CUSTOMER PROBLEM ANALYSIS |
|
3. |
INSPECT BATTERY VOLTAGE |
(a) Measure the battery voltage.
Standard Voltage:
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.
|
4. |
PROBLEM SYMPTOM CONFIRMATION |
|
5. |
PROBLEM SIMULATION |
|
6. |
PROBLEM SYMPTOMS TABLE |
(a) Refer to Problem Symptoms Table.
Click here
|
7. |
REPAIR OR REPLACE |
|
8. |
CONFIRMATION TEST |
NEXT | ![]() |
END |
Toyota CH-R Service Manual > Exterior Panels / Trim: Wheel Opening Moulding(for Front)
Components
COMPONENTS
ILLUSTRATION
*1
FRONT FENDER MOULDING SUB-ASSEMBLY
-
-
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
...
Toyota CH-R Service Manual > Seat Position Sensor: On-vehicle Inspection
ON-VEHICLE INSPECTION
CAUTION / NOTICE / HINT
CAUTION:
Be sure to correctly follow the removal and installation procedures for the seat
position airbag sensor.
PROCEDURE
1. INSPECT SEAT POSITION AIRBAG SENSOR (for Vehicle not Involved in Collision)
(a) Perform a diagnostic system check.
Cli ...