REASSEMBLY
PROCEDURE
1. INSTALL CONSOLE COMPARTMENT DOOR SUB-ASSEMBLY
(a) Engage the guides to install the console compartment door sub-assembly. |
|
(b) Install the 4 screws.
2. INSTALL NO. 2 BOX SIDE PANEL
(a) Engage the guides and claws to install the No. 2 box side panel as shown in the illustration.
![]() |
Install in this Direction (1) |
![]() |
Install in this Direction (2) |
3. INSTALL NO. 1 BOX SIDE PANEL
(a) Engage the guides and claws to install the No. 1 box side panel as shown in the illustration.
![]() |
Install in this Direction (1) |
![]() |
Install in this Direction (2) |
4. INSTALL CONSOLE BOX RETAINER
(a) Engage the claws to install the console box retainer as shown in the illustration.
![]() |
Install in this Direction |
5. INSTALL CONSOLE REAR END PANEL
(a) Engage the clips to install the console rear end panel as shown in the illustration.
![]() |
Install in this Direction |
6. INSTALL NO. 1 POWER OUTLET SOCKET COVER
Click here
7. INSTALL NO. 1 POWER OUTLET SOCKET ASSEMBLY
Click here
Toyota CH-R Service Manual > Side Airbag Sensor(for Center Pillar): Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
side airbag sensor removal/installation are shown below.
Necessary Procedure After Parts Remove ...
Toyota CH-R Service Manual > Meter / Gauge System: Terminals Of Ecu
TERMINALS OF ECU
COMBINATION METER ASSEMBLY
(a) Disconnect the combination meter assembly connectors.
(b) Measure the voltage on the wire harness side connector according to the value(s)
in the table below.
Terminal No.
Wiring Color
Terminal Description
...