Toyota CH-R Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT QUICK HEATER ASSEMBLY (for VALEO Made)

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

Always

Below 1 Ω

3 - 2

Always

Below 1 Ω

3 - 4

Always

Below 1 Ω

5 - 4

Always

Below 1 Ω

If the result is not as specified, replace the quick heater assembly.

*a

Component without harness connected

(Quick Heater Assembly)

    Components
    COMPONENTS ILLUSTRATION *A for VALEO Made *B for DENSO Made *1 COWL SIDE TRIM BOARD LH *2 FRONT DOOR S ...

    Removal
    REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE LH Click here 2. REMOVE COWL SIDE TRIM BOARD LH Click here 3. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY Click here 4 ...

    Other materials:

    Toyota CH-R Service Manual > Vehicle Stability Control System: Skid Control ECU Malfunction (C1300)
    DESCRIPTION The skid control ECU (brake actuator assembly) stores this DTC if malfunctions are found in a circuit inside the ECU by self diagnosis. DTC No. Detection Item DTC Detection Condition Trouble Area C1300 Skid Contr ...

    Toyota CH-R Service Manual > Rear Combination Light Assembly(for Led Type): Inspection
    INSPECTION PROCEDURE 1. INSPECT REAR COMBINATION LIGHT ASSEMBLY LH (a) Apply battery voltage to the rear combination light assembly LH and check that the light comes on. OK: Condition Specified Condition Battery po ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0075