DIAGNOSTIC TROUBLE CODE CHART
AIR CONDITIONING SYSTEM
DTC No. |
Detection Item |
DTC Detection Condition |
Link |
---|---|---|---|
B1411 |
Room Temperature Sensor Circuit |
Any of the following conditions is met:
|
|
B1412 |
Ambient Temperature Sensor Circuit |
When the air conditioning amplifier assembly cannot receive outside temperature sensor data from the combination meter assembly. |
|
B1413 |
Evaporator Temperature Sensor Circuit |
Any of the following conditions is met:
|
|
B1423 |
Pressure Sensor Circuit |
|
|
B1441 |
Air Mix Damper Control Servo Motor Circuit (Passenger Side) |
Air mix damper position sensor value does not change even if air conditioning amplifier assembly operates No. 1 air conditioning radiator damper servo sub-assembly |
|
B1442 |
Air Inlet Damper Control Servo Motor Circuit |
Air inlet damper position sensor value does not change even if air conditioning amplifier assembly operates No. 1 blower damper servo sub-assembly |
|
B1443 |
Air Outlet Damper Control Servo Motor Circuit |
Air outlet damper position sensor value does not change even if air conditioning amplifier assembly operates No. 1 air conditioning radiator damper servo sub-assembly |
|
B1446 |
Air Mix Damper Control Servo Motor Circuit (Driver Side) |
Air mix damper position sensor value does not change even if air conditioning amplifier assembly operates No. 1 air conditioning radiator damper servo sub-assembly |
|
B1451 |
Compressor Solenoid Circuit |
Any of the following conditions is met:
|
|
B1497 |
Communication Malfunction (Bus Ic) |
Any of the following conditions is met:
|
|
B14B2 |
Lost Communication with Front Panel LIN |
Lost communication with air conditioning control assembly |
|
B14B8 |
Refrigerant Shortage |
When following condition is detected in refrigerant shortage check in normal operation: Amount of refrigerant is insufficient |
|
U0100 |
Lost Communication with ECM |
No communication with ECM |
|
U0131 |
Lost Communication with Electric Power Steering ECU |
No communication with power steering ECU assembly |
|
U0142 |
Lost Communication with Main Body ECU |
No communication with main body ECU (multiplex network body ECU) |
|
U0155 |
Lost Communication with Combination Meter |
No communication with combination meter assembly |
|
Toyota CH-R Service Manual > Blind Spot Monitor System: Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)
DESCRIPTION
This DTC is stored when a beam axis adjustment has not been performed for the
blind spot monitor sensor RH (Slave).
HINT:
This DTC is always stored after replacing a blind spot monitor sensor. The purpose
of this DTC is to ensure that a beam axis adjustment is performed. Completin ...
Toyota CH-R Service Manual > Wiper Switch: Components
COMPONENTS
ILLUSTRATION
*1
LOWER STEERING COLUMN COVER
*2
UPPER STEERING COLUMN COVER
*3
WINDSHIELD WIPER SWITCH ASSEMBLY
-
-
...