Toyota CH-R Service Manual: Dtc Check / Clear

DTC CHECK / CLEAR

DTC CHECK USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes.

Body Electrical > Air Conditioner > Trouble Codes

(e) Check for DTCs.

DTC CLEAR USING TECHSTREAM

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes.

Body Electrical > Air Conditioner > Clear DTCs

(e) Clear the DTCs.

    Diagnosis System
    DIAGNOSIS SYSTEM DESCRIPTION Air conditioning system data and Diagnostic Trouble Codes (DTCs) can be read through the Data Link Connector 3 (DLC3) of the vehicle. When the system seems to be mal ...

    Data List / Active Test
    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when decidi ...

    Other materials:

    Toyota CH-R Service Manual > Oil Pan: Removal
    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transaxle oil (CVT) pan sub-assembly removal/installation are shown below. Necessary Procedure ...

    Toyota CH-R Service Manual > Vehicle Stability Control System: Yaw Rate Sensor (C1234,C1472,C1474)
    DESCRIPTION The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via CAN communication. HINT: If there is a malfunction in the bus lines between the yaw rate and acceleration sensor (airbag sensor assembly) and the ...

    © 2017-2019 Copyright www.tochr.net
    0.017