Toyota CH-R Service Manual: Data List / Active Test
DATA LIST / ACTIVE TEST
DATA LIST
HINT:
Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body or Master Switch / Data List.
(e) Read the Data List according to the display on the Techstream.
Body Electrical > Main Body > Data List|
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
ACC SW |
Ignition switch ACC signal |
OFF or ON |
OFF: Ignition switch off ON: Ignition switch ACC |
- |
|
IG SW |
Ignition switch ON signal |
OFF or ON |
OFF: Ignition switch off or ACC ON: Ignition switch ON |
- |
|
RR Door Courtesy SW |
Rear door courtesy light switch (for RH) signal |
OFF or ON |
OFF: Rear door RH closed ON: Rear door RH open |
- |
|
RL Door Courtesy SW |
Rear door courtesy light switch (for LH) signal |
OFF or ON |
OFF: Rear door LH closed ON: Rear door LH open |
- |
|
Back Door Courtesy SW |
Back door courtesy light switch signal |
OFF or ON |
OFF: Back door closed ON: Back door open |
- |
|
Back Door Open |
Back door lock signal |
Prohibt or Permit |
Prohibt: Back door locked Permit: Back door unlocked |
- |
|
D Seat Buckle SW |
Driver side seat belt buckle signal |
OFF or ON |
ON: Driver side seat belt unfastened OFF: Driver side seat belt fastened |
- |
|
Door Lock SW-Lock |
Door control switch assembly lock signal |
OFF or ON |
OFF: Lock side of door control switch assembly not pushed ON: Lock side of door control switch assembly pushed |
- |
|
Door Lock SW-Unlock |
Door control switch assembly unlock signal |
OFF or ON |
OFF: Unlock side of door control switch assembly not pushed ON: Unlock side of door control switch assembly pushed |
- |
|
Door Key SW-Lock |
Driver door key-linked lock / unlock switch lock signal |
OFF or ON |
OFF: Driver door key cylinder not turned to lock position ON: Driver door key cylinder turned to lock position |
- |
|
D Door Key SW-UL |
Driver door key-linked lock / unlock switch unlock signal |
OFF or ON |
OFF: Driver door key cylinder not turned to unlock position ON: Driver door key cylinder turned to unlock position |
- |
|
FR Door Lock Pos |
Front door RH unlock detection switch signal |
LOCK or UNLOCK |
LOCK: Front door RH locked UNLOCK: Front door RH unlocked |
- |
|
FR Door Courtesy SW |
Front door courtesy light switch (for RH) signal |
OFF or ON |
OFF: Front door RH closed ON: Front door RH open |
- |
|
FL Door Lock Pos |
Front door LH unlock detection switch signal |
LOCK or UNLOCK |
LOCK: Front door LH locked UNLOCK: Front door LH unlocked |
- |
|
FL Door Courtesy SW |
Front door courtesy light switch (for LH) signal |
OFF or ON |
OFF: Front door LH closed ON: Front door LH open |
- |
|
Back Door Open Handle SW |
Back door opener switch signal |
OFF or ON |
OFF: Back door closed ON: Back door open |
- |
|
RR-Door Lock Pos SW |
Rear door RH and LH unlock detection switch signal |
OFF or ON |
OFF: Rear door RH and LH locked ON: Rear door RH or LH unlocked |
*1 |
|
RL-Door Lock Pos SW |
Rear door RH and LH unlock detection switch signal |
OFF or ON |
OFF: Rear door RH and LH locked ON: Rear door RH or LH unlocked |
*2 |
|
Unlock Key Twice |
Key-linked 2-step unlock function |
OFF or ON |
Customize setting displayed |
- |
- *1: When checking RR-Door Lock Pos SW, make sure to check it with the rear door LH locked.
- *2: When checking RL-Door Lock Pos SW, make sure to check it with the rear door RH locked.
|
Tester Display |
Measurement Item |
Range |
Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Door Lock Switch Status |
Multiplex network master switch assembly lock signal |
OFF or ON |
OFF: Lock side of multiplex network master switch assembly not pushed ON: Lock side of multiplex network master switch assembly pushed |
- |
|
Door Unlock Switch Status |
Multiplex network master switch assembly unlock signal |
OFF or ON |
OFF: Unlock side of multiplex network master switch assembly not pushed ON: Unlock side of multiplex network master switch assembly pushed |
- |
ACTIVE TEST
HINT:
Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Active Test.
(e) Perform the Active Test according to the display on the Techstream.
Body Electrical > Main Body > Active Test|
Tester Display |
Measurement Item |
Control Range |
Diagnostic Note |
|---|---|---|---|
|
Door Lock |
Door lock motor |
OFF/Unlock/Lock |
- |
|
D-Door Unlock |
Driver door lock motor |
OFF/ON |
- |
|
Trunk and Back-Door Open |
Back door lock motor |
OFF/ON |
- |
Terminals Of Ecu
TERMINALS OF ECU
CHECK INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY AND MAIN BODY ECU (MULTIPLEX NETWORK
BODY ECU)
*A
Main Body ECU (Multiplex Network Body ECU) with 2 Connecto ...
Operation History List
OPERATION HISTORY LIST
NOTICE:
If the vehicle or vehicle controls are operated (for example, during
initial inspection when the vehicle is brought in for repair) before operation
his ...
Other materials:
Toyota CH-R Service Manual > Rear Wiper Rubber: Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR WIPER RUBBER
(a) Install the 2 rear wiper rubber backing plates to the rear wiper rubber.
Install in this Direction
NOTICE:
Install the backing plates facing the correct direction.
(b) Insert the rear wiper rubber with the ...
Toyota CH-R Service Manual > Lighting System: System Diagram
SYSTEM DIAGRAM
HEADLIGHT ASSEMBLY (for LED Headlight)
...
Toyota CH-R Owners Manual
- For safety and security
- Instrument cluster
- Operation of each component
- Driving
- Interior features
- Maintenance and care
- When trouble arises
- Vehicle specifications
- For owners
Toyota CH-R Service Manual
- Introduction
- Maintenance
- Audio / Video
- Cellular Communication
- Navigation / Multi Info Display
- Park Assist / Monitoring
- Brake (front)
- Brake (rear)
- Brake Control / Dynamic Control Systems
- Brake System (other)
- Parking Brake
- Axle And Differential
- Drive Shaft / Propeller Shaft
- K114 Cvt
- 3zr-fae Battery / Charging
- Networking
- Power Distribution
- Power Assist Systems
- Steering Column
- Steering Gear / Linkage
- Alignment / Handling Diagnosis
- Front Suspension
- Rear Suspension
- Tire / Wheel
- Tire Pressure Monitoring
- Door / Hatch
- Exterior Panels / Trim
- Horn
- Lighting (ext)
- Mirror (ext)
- Window / Glass
- Wiper / Washer
- Door Lock
- Heating / Air Conditioning
- Interior Panels / Trim
- Lighting (int)
- Meter / Gauge / Display
- Mirror (int)
- Power Outlets (int)
- Pre-collision
- Seat
- Seat Belt
- Supplemental Restraint Systems
- Theft Deterrent / Keyless Entry
0.0255