INSTALLATION
PROCEDURE
1. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY (for Driver Side)
(a) Install the multiplex network master switch assembly with the 3 screws.
2. INSTALL DOOR CONTROL SWITCH ASSEMBLY (for Front Passenger Side)
|
(a) Engage the claws to install the door control switch assembly. |
|
3. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)
Click here
4. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)
Click here
RemovalToyota CH-R Service Manual > Rear Combination Light Assembly(for Bulb Type): Disassembly
DISASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. REMOVE REAR COMBINATION LIGHT LED
(a) Disconnect the connector.
Remove in this Direction
(b) ...
Toyota CH-R Service Manual > Airbag System: Short in Front Pretensioner Squib RH Circuit (B1900/73-B1903/73)
DESCRIPTION
The front pretensioner squib RH circuit consists of the airbag sensor assembly
and front seat outer belt assembly RH.
The airbag sensor assembly uses this circuit to deploy the pretensioner when
deployment conditions are met.
These DTCs are stored when a malfunction is detected in ...