INSTALLATION
PROCEDURE
1. INSTALL WINDSHIELD WIPER SWITCH ASSEMBLY
(a) Engage the claw to install the windshield wiper switch assembly as shown in the illustration.
![]() |
Install in this Direction |
(b) Connect the 2 connectors.
2. INSTALL UPPER STEERING COLUMN COVER
(a) Engage the clips and claws to connect the upper steering column cover to the lower instrument cover sub-assembly. |
|
(b) Engage the claw to install the upper steering column cover as shown in the illustration.
![]() |
Install in this Direction |
3. INSTALL LOWER STEERING COLUMN COVER
NOTICE:
If the lower steering column cover is installed in the incorrect order, the parts may break.
(a) Engage the claws as shown in the illustration.
![]() |
Install in this Direction |
(b) Engage the claws. |
|
(c) Turn the steering wheel assembly to the left and install the screw.
(d) Turn the steering wheel assembly to the right and install the lower steering column cover with the screw.
Toyota CH-R Service Manual > Blind Spot Monitor System: Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table. Check each sy ...
Toyota CH-R Service Manual > Fuel Lid Opener Switch: Inspection
INSPECTION
PROCEDURE
1. INSPECT FUEL LID OPENER SWITCH
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection
Switch Condition
Specified Condi ...