Toyota CH-R Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY

(a) Apply MP grease to the sliding and rotating areas of the power window regulator motor assembly.

(b) Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.

Torque:

5.4 N·m {55 kgf·cm, 48 in·lbf}

HINT:

When replacing a power window regulator motor assembly, a new power window regulator motor assembly uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.

2. INSTALL FRONT DOOR WINDOW REGULATOR ASSEMBLY

Click here

3. INSTALL NO. 2 FRONT DOOR SERVICE HOLE COVER

Click here

4. INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Click here

5. INSTALL FRONT DOOR SERVICE HOLE COVER

Click here

6. INSTALL FRONT DOOR BELT SEAL

Click here

7. INSTALL FRONT DOOR GLASS INNER WEATHERSTRIP

Click here

8. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Click here

9. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

Click here

10. INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)

Click here

11. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

Click here

12. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

13. INITIALIZE POWER WINDOW CONTROL SYSTEM

Click here

14. INSPECT POWER WINDOW OPERATION

Click here