REMOVAL
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. REMOVE REAR COMBINATION LIGHT COVER
(a) Disengage the claws to remove the rear combination light cover as shown in the illustration.
|
Remove in this Direction |
2. REMOVE REAR COMBINATION LIGHT ASSEMBLY
(a) Apply protective tape around the rear combination light assembly as shown in the illustration.
|
Protective Tape |
(b) Remove the 2 screws.
(c) Pull the rear combination light assembly toward the rear of the vehicle as shown in the illustration to disengage the clip, guide and pin to separate the rear combination light assembly.
NOTICE:
To prevent the rear combination light assembly from falling when disengaging the pins and guides, lightly hold the rear combination light assembly.
|
Remove in this Direction |
|
(d) Disconnect the connector to remove the rear combination light assembly. |
|
Components
InspectionToyota CH-R Service Manual > Transponder Key Ecu: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
transponder key ECU assembly removal/installation are shown below.
Necessary Procedure After Pa ...
Toyota CH-R Service Manual > Electric Parking Brake System: Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC AND FREEZE FRAME DATA (USING TECHSTREAM)
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / ABS/VSC/TRAC/EPB / Trouble Codes.
Chassis > ...