DESCRIPTION
These DTCs are stored if the headlight ECU sub-assembly LH or RH detects an internal malfunction. The headlight ECU sub-assembly LH stores DTC B242C or B242D.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
Note |
|---|---|---|---|---|
|
B242C |
Right Headlight ECU Malfunction |
An internal malfunction occurs in the headlight ECU sub-assembly RH |
Headlight ECU sub-assembly RH |
- |
|
B242D |
Left Headlight ECU Malfunction |
An internal malfunction occurs in the headlight ECU sub-assembly LH |
Headlight ECU sub-assembly LH |
- |
CAUTION / NOTICE / HINT
NOTICE:
After the headlight ECU sub-assembly LH is replaced, vehicle information registration and initialization are necessary.
Click here
PROCEDURE
|
1. |
CLEAR DTC |
(a) Clear the DTCs.
Click here
|
|
2. |
CHECK FOR DTC |
(a) Turn the ignition switch to ON.
(b) Check for DTCs.
Click here
OK:
DTC B242C and B242D are not output.
|
Result |
Proceed to |
|---|---|
|
OK |
A |
|
NG (DTC B242C is output) |
B |
|
NG (DTC B242D is output) |
C |
| A | |
USE SIMULATION METHOD TO CHECK
|
| B | |
REPLACE HEADLIGHT ECU SUB-ASSEMBLY RH |
| C | |
REPLACE HEADLIGHT ECU SUB-ASSEMBLY LH |
Headlamp LH Circuit (B2439,B243A)
Open in IG Circuit (B242E)Toyota CH-R Service Manual > Door / Hatch: Fuel Lid Opener Motor Assembly
Components
COMPONENTS
ILLUSTRATION
*1
FUEL FILLER OPENING LID LOCK RETAINER
*2
FUEL LID LOCK WITH MOTOR ASSEMBLY
Removal
REMOVAL
PROCEDURE
1. REMOVE DECK TRIM SIDE PANEL ASSEMBLY LH
Click here
2. REMOVE FUEL FILLER OPENING LID ...
Toyota CH-R Service Manual > Blind Spot Monitor System: Short to GND or Open in Buzzer (C1ABE)
DESCRIPTION
DTC C1ABE is stored when the blind spot monitor sensor RH (Slave) detects
a short to ground or open in the RCTA buzzer (blind spot monitor buzzer)
circuit.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
...