DESCRIPTION
These DTCs are stored when the CAN communication system is malfunctioning.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
Note |
|---|---|---|---|---|
|
U0073 |
Control Module Communication Bus OFF |
Lost communication with CAN communication line |
CAN communication system |
- |
|
U0100 |
Lost Communication with ECM / PCM "A" |
Lost communication with ECM |
|
- |
|
U0129 |
Lost Communication with Brake System Control Module |
Lost communication with brake actuator assembly (skid control ECU) |
|
- |
|
U0142 |
Lost Communication with Body Control Module "B" |
Lost communication with main body ECU (multiplex network body ECU) |
|
- |
PROCEDURE
|
1. |
CLEAR DTC |
(a) Clear the DTCs.
Click here
|
|
2. |
CHECK FOR DTC |
(a) Turn the ignition switch to ON.
(b) Check for DTCs.
Click here
OK:
DTCs are not output.
| OK | |
USE SIMULATION METHOD TO CHECK
|
| NG | |
GO TO CAN COMMUNICATION SYSTEM
|
Left Headlight ECU Variation Error (B2456)
Lost Communication With Headlamp Control Module "B" (U0242)Toyota CH-R Service Manual > Fog Light Assembly: Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE
1. REMOVE FRONT BUMPER ASSEMBLY
Click here
2. REMOVE FOG LIGHT ASSEMBLY
(a) Remove the 2 screws.
...
Toyota CH-R Service Manual > Fog Light Assembly: Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the LH and RH sides.
The procedure described below is for the LH side.
PROCEDURE
1. INSTALL FOG LIGHT BULB
(a) Turn the fog light bulb in the direction indicated by the arrow shown in
the illustration, and ...