DESCRIPTION
This DTC is stored when the main body ECU (multiplex network body ECU) detects malfunctions in the automatic high beam system.
|
DTC No. |
Detection Item |
DTC Detection Condition |
Trouble Area |
|---|---|---|---|
|
B124B |
Automatic High Beam System |
Malfunction in automatic high beam system |
|
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
Click here
HINT:
If the forward recognition camera stores a DTC for a malfunction of any of the following, this DTC will be stored simultaneously.PROCEDURE
|
1. |
CHECK FOR DTC (HEALTH CHECK) |
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: System Select / Health Check.
(e) Check for DTCs.
|
Result |
Proceed to |
|---|---|
|
Only DTC B124B is output |
A |
|
DTC B124B and other DTCs are output |
B |
| B | |
GO TO OTHER DTC CHART |
|
|
2. |
CHECK FORWARD RECOGNITION CAMERA SYSTEM |
(a) Check if a dynamic radar cruise control system, lane departure alert system and pre-collision system warning message is displayed on the combination meter assembly.
Click here
OK:
No dynamic radar cruise control system, lane departure alert system and pre-collision system warning messages are displayed.
| OK | |
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
|
| NG | |
GO TO FORWARD RECOGNITION CAMERA SYSTEM |
Diagnostic Trouble Code Chart
Automatic High Beam Camera (B124C)Toyota CH-R Service Manual > Center Airbag Sensor Assembly: Components
COMPONENTS
ILLUSTRATION
*A
w/ Rear Air Duct
-
-
*1
AIRBAG SENSOR ASSEMBLY
*2
REAR NO. 2 AIR DUCT
Tightening torque for "Major areas involving basic vehicle performance
...
Toyota CH-R Service Manual > Continuously Variable Transaxle System: Pressure Control Solenoid "J" Electrical (Shift Solenoid Valve SLP) (P2822)
DESCRIPTION
According to current control by the ECM, the shift solenoid valve SLP controls
primary pulley pressure in accordance with the requested gear ratio to perform gear
ratio changes.
*1
Spool Valve
*2
Sleeve
*3
So ...