Toyota CH-R Service Manual: Installation

INSTALLATION

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the RH side and LH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL ROCKER PANEL MOULDING

(a) Engage the clips to install the rocker panel moulding as shown in the illustration.

Install in this Direction (1)

Install in this Direction (2)

(b) Engage the claw to connect the quarter outside moulding LH as shown in the illustration.

Install in this Direction

(c) Install the 5 screws.

(d) Install the 8 new clips.

(e) Remove the protective tape.

2. INSTALL REAR WHEEL HOUSE FRONT PLATE

Click here

    Reassembly
    REASSEMBLY PROCEDURE 1. INSTALL ROCKER PANEL MOULDING PAD HINT: Using the same procedure, remove every rocker panel moulding pad. When installing the rocker panel moulding pad, heat ...

    Roof Drip Side Finish Moulding
    Components COMPONENTS ILLUSTRATION *1 CENTER ROOF DRIP SIDE FINISH MOULDING *2 NO. 1 ROOF DRIP SIDE FINISH MOULDING CLIP ● ...

    Other materials:

    Toyota CH-R Service Manual > Airbag System: Problem Symptoms Table
    PROBLEM SYMPTOMS TABLE HINT: Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each sy ...

    Toyota CH-R Service Manual > Smart Key System(for Start Function): Dtc Check / Clear
    DTC CHECK / CLEAR NOTICE: When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type u ...

    Toyota C-HR (AX20) 2023-2026 Owner's Manual

    Toyota CH-R Owners Manual

    Toyota CH-R Service Manual

    © 2017-2026 Copyright www.tochr.net
    0.0074