INSTALLATION
CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. INSTALL REAR DOOR OUTSIDE MOULDING
(a) Remove the peeling paper from the face of the outside moulding retainer.
HINT:
After removing the peeling paper, keep the exposed adhesive free from foreign matter.
(b) Engage the clips as to install rear door outside moulding as shown in the illustration.
|
Install in this Direction |
(c) Remove the protective tape.
(d) Install the gasket and nut.
(e) Install the hole cover.
ReassemblyToyota CH-R Service Manual > Power Window Control System: Terminals Of Ecu
TERMINALS OF ECU
CHECK MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
(a) Disconnect the J6 multiplex network master switch assembly connector.
(b) Measure the voltage and resistance according to the value(s) in the table
below.
HINT:
Measure the values on the wire harness side with the connector ...
Toyota CH-R Service Manual > Brake (front): Front Disc Brake Pad
Components
COMPONENTS
ILLUSTRATION
*1
FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT
*2
FRONT DISC BRAKE CYLINDER ASSEMBLY
*3
FRONT DISC BRAKE PAD
*4
FRONT BRAKE PAD RADIAL SPRING
*5
...