Operating instructions
Turning the
switch
turns on the rear window wiper and washer as follows:
*2
*2
*2*1: For U.S.A.
*2: For Canada

Washer/wiper dual operation
The wiper will automatically operate a couple of times after the washer squirts.

■The rear window wiper and washer can be operated when
Vehicles without a smart key system
The engine switch is in the "ON" position.
Vehicles with a smart key system
The engine switch is in IGNITION ON mode.
■If no windshield washer fluid sprays Check that the washer nozzle is not blocked if there is washer fluid in the windshield washer fluid reservoir.
■When the rear window is dry Do not use the wiper, as it may damage the rear window.
■When the washer fluid tank is empty Do not operate the switch continually as the washer fluid pump may overheat.
■When a nozzle becomes blocked In this case, contact your Toyota dealer.
Do not try to clear it with a pin or other object. The nozzle will be damaged.
Windshield wipers and washer
RefuelingToyota CH-R Service Manual > Oil Cooler: Removal
REMOVAL
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration)
that must be performed after parts are removed, installed, or replaced during the
oil cooler removal/installation are shown below.
Necessary Procedure After Parts Removed/Instal ...
Toyota CH-R Service Manual > Can Communication System: Check Bus 2 Lines for Short Circuit
DESCRIPTION
There may be a short circuit between the CAN main bus lines and/or CAN branch
lines when the resistance between terminals 18 (CA4H) and 17 (CA4L) of the central
gateway ECU (network gateway ECU) is below 54 Ω.
Symptom
Trouble Area
Resistance ...