Toyota CH-R Service Manual: CD cannot be Ejected

PROCEDURE

1.

CHECK OPERATION

(a) Press the CD eject switch of the radio receiver assembly for 5 seconds or more and check that the CD is ejected.

OK:

CD is ejected.

NG

REPLACE RADIO RECEIVER ASSEMBLY

OK

2.

REPLACE CD AND RECHECK

(a) Replace the CD with a known good one and check that the malfunction disappears.

OK:

CD is ejected.

OK

END (CD WAS FAULTY)

NG

REPLACE RADIO RECEIVER ASSEMBLY

    Sound Quality is Bad Only when CD is Played (Volume is Too Low)
    PROCEDURE 1. REPLACE CD AND RECHECK (a) Replace the CD with a known good one and check that the malfunction disappears. OK: Malfunction disappears. OK ...

    CD cannot be Inserted / Played or CD is Ejected Right After Insertion
    PROCEDURE 1. CHECK IF A PROPER CD IS INSERTED (a) Make sure that the CD is an audio CD or a CD with an MP3 or WMA file, and that it is not deformed, flawed, stained ...

    Other materials:

    Toyota CH-R Service Manual > Toyota Entune System: Dtc Check / Clear
    DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Telematics / Trouble Codes. Body Electrical > Telematics > Trouble Codes (e) Check for DTCs. Click here ...

    Toyota CH-R Service Manual > Blind Spot Monitor System: Power Source Circuit
    DESCRIPTION This circuit provides power to operate the blind spot monitor sensor. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following procedure. PROCEDURE 1. CHECK HARNESS AND CONNECTOR ...

    © 2017-2020 Copyright www.tochr.net
    0.0187